Products 97-120 of 120
Show
Magnet Wire Kit
Price: $20.78
View
Availability: Back Order
Sparkfun Item #: PRT-11363 -

"Magnet wire is super useful stuff, and when you need it there’s nothing else that will work. Whether you’re winding a transformer or choke, fashioning your own motors or just playing with electromagnetism in general, nothing beats this thin-gauge enameled wire. This kit comes with three common gauges of wire: 22, 26 and 30AWG. Everyone has his or her own method for removing the enamel insulation and make a connection to this stuff, but a little abrasion with some sandpaper or...

Molex Jumper 2 Wire Assembly
OOD!
Price: $1.65
View
Availability: Back Order
Sparkfun Item #: PRT-09918 -

"This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin Molex connector with 0.1" spacing on one end, bare cable on the opposite end. It also comes with the mating connector for the Molex. Dimensions: 6" length Documents: Datasheet "

Molex Jumper 6 Wire Assembly
OOD!
Price: $3.39
View
Availability: Back Order
Sparkfun Item #: PRT-09922 -

"This is a simple six wire cable. Great for jumping from board to board or just about anything else. There is a 6-pin Molex connector with 0.1" spacing on one end, bare cable on the opposite end. It also comes with the mating connector for the Molex. Dimensions: 6" length Documents: Datasheet "

Multimeter Probes - Tweezers
OOD!
Price: $8.61
View
Availability: Back Order
Sparkfun Item #: TOL-11060 -

"Testing surface-mount components with standard test leads is anything but easy. Everyone has their own method: some people tackle it with teamwork and have a friend (or grad student) hold the probes, some people have adapted a sort of chopsticks-like technique, but the best way by far is probably just to buy these handy tweezer probes! Tweezer probes connect to your existing instrumentation with shrouded banana connectors and allow you to easily test small parts with one hand. The large...

Qwiic Cable - 100mm
Price: $2.74
View
Availability: Back Order
Sparkfun Item #: PRT-14427 -

"This is a 100mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but can be used for other applications as well. Each Qwiic Cable’s wires have been color coded to Red, Black, Blue, and Yellow. The SparkFun Qwiic connect system is an ecosystem of I2C sensors, actuators, shields, and cables that make prototyping faster and less prone to error. All Qwiic enabled boards use a common 1mm pitch, 4-pin JST connector. This reduces...

Qwiic Cable - 200mm
OOD!
Price: $2.74
View
Availability: Back Order
Sparkfun Item #: PRT-14428 -

"This is a 200mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but can be used for other applications as well. Each Qwiic Cable’s wires have been color coded to red, black, blue and yellow. The SparkFun Qwiic connect system is an ecosystem of I2C sensors, actuators, shields and cables that make prototyping faster and less prone to error. All Qwiic-enabled boards use a common 1mm pitch, 4-pin JST connector. This reduces...

Qwiic Cable - 500mm
OOD!
Price: $3.73
View
Availability: Back Order
Sparkfun Item #: PRT-14429 -

"This is a 50mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but can be used for other applications as well. Each Qwiic Cable’s wires have been color coded to red, black, blue and yellow. This cable is used for connecting Qwiic boards that need to be very far away from the controller. Note that I2C signals will degrade over longer distances. We recommend keeping the connections to 1 meter or less. That said, we’ve...

Qwiic Cable - 50mm
OOD!
Price: $1.65
View
Availability: Back Order
Sparkfun Item #: PRT-14426 -

"This is a 50mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but can be used for other applications as well. Each Qwiic Cable’s wires have been color coded to red, black, blue and yellow. The SparkFun Qwiic connect system is an ecosystem of I2C sensors, actuators, shields and cables that make prototyping faster and less prone to error. All Qwiic-enabled boards use a common 1mm pitch, 4-pin JST connector. This reduces...

Qwiic Cable - Breadboard Jumper (4-pin)
OOD!
Price: $2.61
View
Availability: Back Order
Sparkfun Item #: PRT-14425 -

"This is a jumper adapter cable that comes pre-terminated with a female Qwiic JST connector on one end and a breadboard hookup pigtail on the other. This cable makes it easy to connect components with a Qwiic connector to a breadboard or an Arduino-based device’s pins. The 28AWG wire’s length is 150mm (about 5.9 inches). The adapter’s wires have been color coded to red, black, blue and yellow. Additionally, the female Qwiic connector features a basic 1mm pitch, while the male...

Raspberry Pi - GPIO Ribbon Cable (6")
OOD!
Price: $5.13
View
Availability: Back Order
Sparkfun Item #: CAB-11489 -

"This 2x13 flat ribbon-cable fits the GPIO headers on the Raspberry Pi so you can easily connect to the low-level peripherals and get hacking! This cable has 0.1"-spaced connectors and is keyed for polarity. Check the related items below for the mating connector! Dimensions: 6" long Documents: Datasheet " ...

Raspberry Pi GPIO Ribbon Cable - 40-pin, 6" (RPi 3, RPi2, B+)
OOD!
Price: $4.35
View
Availability: Back Order
Sparkfun Item #: CAB-13028 -

"This 2x20 flat ribbon-cable fits the GPIO headers on the Raspberry Pi 3, 2, and B+ so you can easily connect to the low-level peripherals and get hacking! This cable has 0.1"-spaced connectors and is keyed for polarity. Dimensions: 6" long Documents: Datasheet Product Video " ...

Raspberry Pi GPIO Shrouded Header - 2x20 (RPi2, B+)
OOD!
Price: $1.65
View
Availability: Back Order
Sparkfun Item #: PRT-13054 -

"This 2x20 shrouded header has the same number and spacing of pins as the Raspberry Pi 2 and Model B+ so you can easily connect via ribbon cable to the low-level peripherals and get hacking! This through-hole header has 40 0.1"-spaced pins and is keyed for polarity. Check the related items below for the mating cable! Documents: Datasheet " ...

Raspberry Pi Zero Camera Cable
OOD!
Price: $10.35
View
Availability: Back Order
Sparkfun Item #: PRT-14272 -

"The Raspberry Pi Zero and Zero W are both equipped with a smaller CSI (Camera Serial Interface) port than on a full-sized Raspberry Pi board — luckily, that’s where this cable can help! The Raspberry Pi Zero Camera Cable replaces the pre-existing camera module cable, allowing your Zero or Zero W light and imaging capabilities. This cable measures 15cm from end to end and can easily be swapped in and out. Note: This product only includes the CSI cable and does NOT include a...

Ribbon Cable - 10 wire (15ft)
Price: $8.61
View
Availability: Stocked
Sparkfun Item #: CAB-10647 -

"Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness. This is a 15ft. length of 10-wire ribbon cable. Check the related products below for crimp-on connectors that will fit this cable. Documents: Datasheet " ...

Ribbon Cable - 10 wire (3ft)
OOD!
Price: $1.65
View
Availability: Back Order
Sparkfun Item #: CAB-10649 -

"Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness. This is a 3ft. length of 10-wire ribbon cable. Check the related products below for crimp-on connectors that will fit this cable. Documents: Datasheet " ...

Ribbon Cable - 6 wire (15ft)
OOD!
Price: $5.13
View
Availability: Back Order
Sparkfun Item #: CAB-10646 -

"Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness. This is a 15ft. length of 6-wire ribbon cable. Check the related products below for crimp-on connectors that will fit this cable. Documents: Datasheet " ...

RockBLOCK 9603 Accessory Cable
OOD!
Price: $8.61
View
Availability: Back Order
Sparkfun Item #: CAB-14720 -

"This is a simple accessory cable meant to be used in conjunction with the RockBLOCK 9603. The RockBLOCK 9603 Accessory Cable is terminated with a simple 10-pin molex-style connector at one end and a male hookup pigtail at the other. This accessory cable will help speed up your development time, meaning you no longer need to terminate and crimp your own connector for the RockBLOCK 9603. If you’re going to connect the RockBLOCK 9603 to anything other than your computer’s USB port,...

Sensor Cable - Electrode  Pads (3 connector)
OOD!
Price: $8.61
View
Availability: Back Order
Sparkfun Item #: CAB-12970 -

"This is your simple three conductor sensor cable with electrode pad leads. These cables are 24" long and feature a 3.5mm audio jack connector on one end with snap style receptacles for biomedical sensor pads. Each cable comes in a red/blue/black set. Dimensions: 24" Long Documents: Product Video "

Spade Connector Wire - 3ft, Female (2 Pack)
OOD!
Price: $3.39
View
Availability: Back Order
Sparkfun Item #: CAB-14166 -

"These simple 24AWG wires are terminated with a female insulated spade connector at one end and a braided wire lead at the other. Each wire is 3 feet long and is capable of supporting a high voltage of 300VDC. Each order comes in a pack of two! We use these cables almost exclusively on our Spectacle Button Board, but that doesn’t mean you can’t find a different use for them! Documentation: Dimensional Drawing Features: 3ft (0.9m) length " ...

U Shape Jumper Wires (Box)
OOD!
Price: $11.21
View
Availability: Back Order
DFRobot Item #: FIT0122 -

This is a time saving kit of jumper wires - cut, stripped,bent 90 degree on both ends for easy insertion and your prototyping pleasure. Make your prototyping neat and looks nicer, The box included with this kit are 14 various lengths of 22AWG wire - 2, 5, 7, 10, 12, 15, 17, 20, 22, 25, 50, 75, 100, and 125mm - 10 pieces of each. Various colors of jumper wire, perfectly fit for breadboard and protoboard. 140pcs a box, get one and use in your future project again and again! |Specification| #22...

U Shape Jumper Wires(140pcs pack)
Price: $9.40
View
Availability: Stocked-NoBackOrder
Elecrow Item #: EL-PCW14000A -

       This box including over 10 different length(from 3mm-125mm) and various colors of jumper wire, perfectly fit breadboard and protoboard. 140pcs per box, you can use it over and over again!

UHF RFID Cable (TNC to RP-SMA)
Price: $8.61
View
Availability: Back Order
Sparkfun Item #: CAB-14132 -

"This is a very simple 1m long TNC to RP-SMA cable. We like to use this cable to connect our ultra high-frequency RFID antennas to an equally powerful reader board. This cable is perfect for extending pre-existing cables to give yourself a better range of operations when managing your RFID projects. Each cable is capable of a nominal impedance of 50Ω with a cutoff frequency of 39GHz. If you are looking for a good antenna to pair this cable with, we recommend our UHF RFID Antenna. Note: If...

Wire Wrap Wire - Blue (Solid, 30AWG, 100ft)
OOD!
Price: $29.11
View
Availability: Back Order
Sparkfun Item #: PRT-14913 -

"This is a 100ft spool of blue wire wrap wire. These wires are 30AWG with solid cores. Ideally suited for wire wrapping and many other applications, this wire is OFHC (oxygen free high conductivity) making it a flexible yet abrasion resistant wire. Documents: Datasheet (p. 44) "

Wire Wrap Wire - White (Solid, 30AWG, 100ft)
OOD!
Price: $29.11
View
Availability: Back Order
Sparkfun Item #: PRT-14914 -

"This is a 100ft spool of white wire wrap wire. These wires are 30AWG with solid cores. Ideally suited for wire wrapping and many other applications, this wire is OFHC (oxygen free high conductivity) making it a flexible yet abrasion resistant wire."