Products 2401-2424 of 2425
Show
SparkFun Venus GPS with SMA Connector
Price: $86.86
View
Availability: Stocked
Item #: GPS-11058 -

"This is the latest version of our Venus GPS board; the smallest, most powerful, and most versatile GPS receiver we carry. It’s based on the Venus638FLPx, the successor to the Venus634LPx. The Venus638FLPx outputs standard NMEA-0183 or SkyTraq Binary sentences at a default rate of 9600bps (adjustable to 115200bps), with update rates up to 20Hz! The Venus638FLPx also allows for limited on-chip logging (check out the firmware below), as well as external logging using a SPI flash memory...

SparkFun GPS Module - Copernicus II DIP (12 Channel)
Price: $132.08
View
Availability: Back Order
Item #: GPS-11858 -

"The Copernicus II is a great GPS module from Trimble, but the SMD module prohibits immediate gratification. This DIP allows the customer to gain direct access to the pins on the SMD module. Simply provide 2.7 - 3.3VDC. The Copernicus II DIP breakout has an impedance-matched, end-launch, standard SMA connector that will mate with our SMA GPS antennas listed below. This revision of the board fixes a few silkscreen errors and adds a jumper between the VCC and XSTBY pins. Not sure which GPS...

GPS Receiver - EM-506 (48 Channel)
Price: $69.47
View
Availability: Back Order
Item #: GPS-12751 -

"The EM-506 GPS receiver from USGlobalSat based on the spectacular SiRF StarIII chipset. This complete module is built upon the same technology as the ET-301, but includes on-board voltage regulation, LED status indicator, battery backed RAM, and a built-in patch antenna! 6-pin interface cable included. This EM-506 GPS module is powered by SiRF Star IV, it can provide you with superior sensitivity and performance even in urban canyon and dense foliage environment. With SiRF CGEE (Client...

GPS Module - Venus638FLPx-L 20Hz (14 Channel)
Hot!
Price: $69.47
View
Availability: Stocked
Item #: GPS-10919 -

"Venus638FLPx is a high performance, low cost, single chip GPS module targeting mobile consumer and cellular handset applications. It offers very low power consumption, high sensitivity, and best in class signal acquisition and time-to-first-fix performance. Venus638FLPx contains all the necessary components of a complete GPS module, includes 1.2dB cascaded system NF RF front-end, GPS baseband signal processor, 0.5ppm TCXO, 32.768kHz RTC crystal, RTC LDO regulator, and passive components. It...

Ribbon Connector - GP-2106
Hot!
Price: $2.61
View
Availability: Stocked
Item #: GPS-11010 -

"This ZIF connector mates with the 6-conductor ribbon cable for the GP-2106 GPS module. Use it to roll your own GP-2106 carrier board! Documents: Datasheet (FH34SRJ-6S-0.5SH) "

GPS Receiver - GP-735 (56 Channel)
Sale!
Price: $79.91
View
Availability: Back Order
Item #: GPS-13670 -

"The GP-735 is a slim, ultra-high performance, easy to use GPS smart antenna receiver. With -162dBm tracking sensitivity and only 29 second cold start time, the GP735 is a tiny, yet powerful, piece of tech. The slim design makes it ideal for applications where you don’t have a lot of space to work in. Really it’s quite small. This 56-channel GPS module, based on the uBlox 7th generation chipset, has an operating voltage of 3.3~5.5V, an antenna on board, and connects to your system...

GPS Receiver - GP-20U7 (56 Channel)
Sale!
Price: $29.12
View
Availability: Back Order
Item #: GPS-13740 -

"The GP-20U7 is a compact GPS receiver with a built-in high performances all-in-one GPS chipset. The GP-20U7 accurately provides position, velocity, and time readings as well possessing high sensitivity and tracking capabilities. Thanks to the low power consumption this receiver requires, the GP-20U7 is ideal for portable applications such as tablet PCs, smart phones, and other devices requiring positioning capability. This 56-channel GPS module, that supports a standard NMEA-0183 and uBlox 7...

SparkFun GPS Logger Shield
Sale!
Price: $86.86
View
Availability: Back Order
Item #: GPS-13750 -

"The SparkFun GPS Logger Shield equips your Arduino with access to a GPS module, µSD memory card socket, and all of the other peripherals you’ll need to turn your Arduino into a position-tracking, speed-monitoring, altitude-observing wonder logger. The shield is based around a GP3906-TLP GPS Module – a 66-channel GPS receiver featuring a MediaTek MT3339 architecture and up to a 10Hz update rate. The GPS module will stream constant position updates over a simple TTL-level...

SparkFun Mini GPS Shield
Sale!
Price: $24.26
View
Availability: Back Order
Item #: GPS-14030 -

"The SparkFun Mini GPS Shield equips your Arduino Mini with access to a GPS module, µSD memory card socket and all of the other peripherals you’ll need to turn your Arduino into a position-tracking, speed-monitoring, altitude-observing wonder logger. The shield is based around the GP-735 GPS module, a 56-channel GPS receiver featuring a uBlox 7th generation chip set and an up to 10Hz update rate. The board also uses a level shifter, so there’s no need to worry about the logic...

GPS Mouse - GP-808G (72 Channel)
Sale!
Price: $66.00
View
Availability: Back Order
Item #: GPS-14198 -

"The GPS Mouse is a combination GPS and Compass in a self contained module perfect for UAV and autonomous vehicle enthusiasts. The The GP-808G inside the Mouse is a highly sensitive GPS module that can accurately provide position, velocity, and time readings. This module is highly accurate and easy to use, requires almost no set-up time, and is very easy to embed into your projects! This 72-channel GPS receiver, that supports a standard NMEA-0183 and uBlox 8 protocol, has low power consumption...

GPS Receiver Module SMD - S1315F
Sale!
Price: $22.95
View
Availability: Back Order
Item #: DD-14239 -

"The S1315F SMD IC is a small form factor 65-channel GPS module solution intended for a broad range of OEM products, where fast and easy system integration and minimal development risk is required. You only need to provide DC power of 3.0V to 3.6V and GPS signal; the S1315F will output navigation solution in standard NMEA-0183 protocol format. We found quite a few of these on our last Inventory Day, but we don’t actually use them on any of our boards. We have made them available at a...

SparkFun GPS Breakout - XA1110 (Qwiic)
Sale!
Price: $86.86
View
Availability: Back Order
Item #: GPS-14414 -

"The SparkFun XA1110 GPS Breakout is a small I2C-supported module built for easy hookup, thanks to our Qwiic Connect System. Equipped with the XA1110 GPS module from GTOP, this board utilizes the MediaTek MT3333 chipset, loaded with specialized SparkFun firmware that enables both I2C and serial ports simultaneously. Using I2C means you won’t have to tie up your serial port with GPS, leaving it open to other possibilities. This GPS Breakout supports up to 210 PRN channels with 99 search...

Ublox GPS-RTK (Qwiic) - NEO-M8P-2
Sale!
Price: $312.92
View
Availability: Back Order
Item #: SPX-14980 -

"Thanks to GPS you can quickly know where you are anywhere on the globe within 30 seconds. Pretty impressive! But what if you need better accuracy than the 2.5 meters accuracy that GPS provides? GPS Real Time Kinematics (RTK) has 25mm accuracy. You can now know where you are (or any object) within one inch. The SparkFun GPS-RTK board is a powerful breakout board for the the NEO-M8P-2 module from Ublox. The NEO-M8P-2 module is the top-of-the-line module for high accuracy GNSS and GPS location...

SparkFun Pi Wedge (Preassembled)
Price: $19.04
View
Availability: Stocked
Item #: BOB-13717 -

"This is the SparkFun Pi Wedge, a small board that connects to the 40-pin GPIO connector on the Raspberry Pi and breaks the pins out to breadboard-friendly arrangement and spacing, and even adds a couple of decoupling capacitors on the power supply lines. The “Wedge” also makes the initial bring-up process easier - you can plug an FTDI Basic module into the built-in serial port. Each version of this Pi Wedge comes preassembled and can be inserted into the RPi’s GPIO port that...

Raspberry Pi Camera Module V2
Sale!
Price: $62.50
View
Availability: Stocked
Item #: DEV-14028 -

"This 8mp camera module is capable of 1080p video and still images that connect directly to your Raspberry Pi. This is the plug-and-play-compatible latest version of the Raspbian operating system, making it perfect for time-lapse photography, recording video, motion detection and security applications. Connect the included ribbon cable to the CSI (Camera Serial Interface) port on your Raspberry Pi, and you are good to go! The board itself is tiny, at around 25mm x 23mm x 9mm and weighing in at...

Pimoroni Unicorn HAT
Price: $54.69
View
Availability: Stocked
Item #: DEV-14037 -

"The Pimoroni Unicorn HAT is a “shield” for the Raspberry Pi that sports a matrix of 64 (8x8) addressable RGB LEDs that are powered directly from the Pi. The Unicorn HAT provides a wash of controllable color that is ideal for mood lighting, 8x8 pixel art, persistence of vision effects, status indications, or just blasting color into your surroundings. Each Pimoroni Unicorn Hat easily snaps on top of a Raspberry Pi equipped with a 40-pin (2x20) GPIO. Pimoroni has created a GitHub...

Pimoroni Blinkt!
Price: $10.35
View
Availability: Stocked
Item #: DEV-14038 -

"The Pimoroni Blinkt! is a “shield” for the Raspberry Pi, equipped with eight super-bright and addressable RGB LEDs that make it ideal for adding visual notifications to your Pi. Each LED is individually controllable and dimmable, allowing you to create gradients, pulsing effects, or just flash them on and off like crazy. Each Pimoroni Blinkt! easily snaps on top of a Raspberry Pi equipped with a 40-pin (2x20) GPIO. Pimoroni has created a GitHub repository bundling the Blinkt!...

Pimoroni Explorer HAT Pro
Price: $39.91
View
Availability: Stocked
Item #: DEV-14039 -

"The Pimoroni Explorer HAT Pro is a “shield” for the Raspberry Pi and provides you with the perfect prototyping sidekick for your Pi. The Explorer HAT Pro has a heap of useful input and output options that will take your Raspberry Pi projects to the next level. This add-on board is great for driving motors, using analog sensors, interfacing with 5V systems and touch (even fruit-based!) interfaces. Each Pimoroni Explorer HAT Pro easily snaps on top of a Raspberry Pi equipped with a...

DAQCplate
Sale!
Price: $66.93
View
Availability: Back Order
Item #: DEV-14148 -

"The DAQCplate (Data Acquisition and Controller) from Pi-Plates adds a rich set of input/output options to your Raspberry Pi. It includes seven powerful digital outputs for driving external devices such as relays and high-current LEDs, as well as eight analog-to-digital inputs for measuring temperature, voltage, humidity and more. Additionally, there are eight digital inputs, two analog outputs and seven general-purpose indicator LEDs. Pi-Plates are a family of stackable and interchangeable...

MOTORplate
Price: $66.93
View
Availability: Back Order
Item #: DEV-14149 -

"The MOTORplate from Pi-Plates brings a suite of professional motion control features to your Raspberry Pi. These plates can each control a combination of two stepper motors, four DC motors or one stepper and two DC motors. An onboard microprocessor does all the hard work including controlling acceleration trajectories and microstepping. By offloading these functions, your Raspberry Pi is free to perform other tasks. Use this board to control a precision XY stage driven by stepper motors. Or,...

RELAYplate
Sale!
Price: $87.54
View
Availability: Back Order
Item #: DEV-14150 -

"The RELAYplate from Pi-Plates is the first dedicated relay board for the Raspberry Pi designed to meet the safety requirements of UL 60950 while being capable of switching 120 volts AC. Each of the seven relays is UL rated to switch 1 amp at 120volts AC or 30 volts DC. And, like all Pi-Plates, you can stack these boards to increase your relay count to 56 using eight plates. The RELAYplate board is compatible with the DAQCplate and MOTORplate, allowing you to create the perfect stack of boards...

Raspberry Pi 3 B+
Price: $83.37
View
Availability: Back Order
Item #: DEV-14643 -

"Everyone knows and loves the Raspberry Pi, but what if the wireless capabilities only got better? The Raspberry Pi 3 B+ is here to provide you with the same Pi as before, but now with gigabit and PoE capable Ethernet, as well as better overheating protection for the 64-bit processor. The credit-card-sized computer is capable of many of the things your desktop PC does, like spreadsheets, word processing and playing high-definition video and games. It can run several flavors of Linux (and even...

Raspberry Pi 3 B+ Starter Kit
Sale!
Price: $191.88
View
Availability: Stocked
Item #: KIT-14644 -

" There’s a lot of Raspberry Pi information going around lately. Whether it’s Pi 3, Zero, Zero W or one of the many previous iterations, any forum will have thousands of people giving all the answers possible to a problem. Though most methods work for any version, it can be tough to decide which information to choose. The Raspberry Pi 3 B+ Starter Kit is a great way to gain a solid introduction to the small, credit-card-sized computer. With this kit you will be able to get your Raspberry Pi 3...

Raspberry Pi 3 A+
Price: $62.50
View
Availability: Stocked
Item #: DEV-15139 -

Raspberry Pi 3 A+ How does a more compact and more economic Raspberry Pi sound to you? The Raspberry Pi 3 A+ is here and, like the Raspberry Pi 3 Model B+, it boasts a 64-bit quad core processor running at 1.4GHz, dual-band 2.4GHz and 5GHz wireless LAN, and Bluetooth 4.2/BLE. The RPi3 A+ is still equipped with the same 64-bit processor as the B+ version but has removed the Ethernet connector and three of the USB ports (leaving you with just one). It still also has the same 2x20 GPIO header and...