Double H driver module uses the amply powerful ST L298N dual full-bridge driver to drive a full 2amps per channel and supply 2 channels along with forward and reverse capability. If you're looking to control DC motors in a smart and easy way this is a great option with loads of grunt and reliability.
An integrated high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels (pin high, pin low for Arduino) and drive inductive loads such as relays, solenoids, DC and stepping motors. Two enable inputs are provided to enable or disable the device independently of the input signals. The emitters of the lower transistors of each bridge are connected together and the corresponding external terminal can be used for the connection of an external sensing resistor. An additional supply input is provided so that the logic works at a lower voltage.
Features:
- Light weight, small dimension
- Super driver capacity
-2A peak (1Amp nominal) per channel and 4 channels
-Bond channels for 2Amp continuous and 2 channels
- FWD protection
- Heavy load Heat sink
- 2 current probe port
- Power selection switch
- 4 pull up resistor switch
- 2 DC motor/ 4 coil dual phrase stepper motor output
- Motor direction indication LED
- 4 standard mouting hole
Spec:
- Driver: L298
- Driver power supply: +5V~+46V
- Driver Io: 2A
- Logic power output Vss: +5~+7V (internal supply +5V)
- Logic current: 0~36mA
- Controlling level: Low -0.3V~1.5V, high: 2.3V~Vss
- Enable signal level: Low -0.3V~1.5V, high: 2.3V~Vss
- Max power: 25W (Temperature 75 cesus)
- Working temperature: -25C~+130C
- Dimension: 60mm*54mm
- Driver weight: ~48g
- Other extensions: current probe, controlling direction indicator, pull-up resistoer switch, logic part power supply.
Applications:
- MCU controlled vehicle
- Wheel robot
Document: