Funduino Nano - Low Cost 100% Clone
(With Free USB Cable)
Sometimes you just want something inexpensive and perfectly compatible to implement a project on. This is probably the board you've been looking for.
It's a clone of the Arduino Nano V3.0 but far less expensive and functionally the same and it comes with a free USB cable. We use these boards for quick projects when we don't want to spend a lot on a project.
They also come with an FTDI chip on board meaning you don't need an external programmer. Just plug it into your computer via USB and get started.
Benefits
-Fantastic price - pick up a few extras and if you fry them, it's not the end of the world.
-FTDI Chip onboard meaning no external programmer needed
-Comes with a free USB cable
-100% Arduino nano compatible
-Warranty via MindKits so you can buy with confidence
Specifications
Microcontroller Atmel ATmega328
Operating Voltage (logic level) 5 V
Input Voltage (recommended) 7-12 V
Input Voltage (limits) 6-20 V
Digital I/O Pins 14 (of which 6 provide PWM output)
Analog Input Pins 8
DC Current per I/O Pin 40 mA
Flash Memory 32 KB (of which 2KB used by bootloader)
SRAM 2 KB
EEPROM 1 KB
Clock Speed 16 MHz
Features
Automatic reset during program download
Power OK blue LED on the bottom
Green (TX), red (RX) and orange (L) LED
+5V to AREF jumper
Auto sensing/switching power input
Small mini-B USB for programming and serial monitor (cable not included)
ICSP header for direct program download
Power OK blue LED on the bottom
Standard 0.1" spacing DIP (breadboard friendly)
Manual reset switch
Note
Sometimes the nano get's lost when reset. If this happens, unplug it and plug it in again and it'll show up again.