Products 265-288 of 292
Show
EL wire 2xAA pocket inverter
Price: $6.67
View
Availability: Stocked-NoBackOrder
Item #: EL-DEL00803AA -

This is a small portable EL wire inverter. Powered by 2 pcs of AA batteries (not included). It can be used to drive 1 to 5 meter of Elecrow high-brightness EL wire. It comes with a switch to help you select the on/off/slow blink/fast blink mode. There's a removable cover and a belt clip you can use that to attach to clothing and hats on the back. Comes with a 2.5mm pitch female JST connector. The EL inverter needs a "load" to work. Do not run the inverter less than 3 cm long of EL wire!...

Adaptor Wire For EL Shield(4pcs pack)
Price: $1.17
View
Availability: Stocked-NoBackOrder
Item #: EL-ACS10100EL -

Adaptor wire special designed for the Elecrow 8-channel EL Shield, to connect the standard EL modules such as EL wire and tape to the EL Shield.SpecificationsConnector: JST2.0Length: 10cm

5A 75W DC-DC Module
Price: $8.68
View
Availability: Stocked-NoBackOrder
Item #: EL-PC0575DC -

    This module integrated a volage meter with the DC-DC converter ? XL4015, with this module, you can monitor your project much more easier. The voltage meter can measure the input voltage or output voltage, which is adjustable by the protentiometer, with a precision of ?0.1V.Note that the voltage meter would not work if the input voltage below 4V. Press the button (right) to switch voltage to measure, between the input voltage and output voltage. There are 2 LEDs to...

9V Battery DC Jack
Price: $0.67
View
Availability: Stocked-NoBackOrder
Item #: EL-PSB00901B -

    This adapter consists of a 9V battery clip and a standard 5.5*2.1mm center positive barrel jack, it applied to power any device such as Arduino Uno, that needs 9V input voltage and has on-board barrel jack.      ...

Lipo Charger
Price: $14.70
View
Availability: Stocked-NoBackOrder
Item #: EL-PSB01012B -

    The LiPo Charger is extremely affordable and easy to use. No programming is required. Plug it in and it works. The internal charger IC handles all the power flow between the various components.     The LiPo Charger board will Show red LED to alarm when the battery is low power, or it will show Green. It allows you ride the solar wave to run your favorite 5V device. The LiPo Charger board is the ideal green power solution for your outdoor sensor...

BreadBoard Power Supply
Price: $5.27
View
Availability: Stocked-NoBackOrder
Item #: EL-PSB02011B -

    This power module is design for the standard bread board. Its tiny design doesn't waste your proto zone. This breadboard power supply support Mini USB power supply and power jack 7-12V supply. You can select 5v or 3.3v supply by using jumper cap. Through this board, you can give power to both power lane of the breadboard.      Features 3.3v / 5v power supply optional Mini USB or Exteral power supply optional Wiki & External links...

5V 15M Invertor for EL Wire
Price: $10.18
View
Availability: Stocked-NoBackOrder
Item #: EL-PC0515IN -

     Invertor for EL wires or tapes, special designed for the Elecrow 8-channel EL Shield, can drive EL wire up to 15M . Specification Input voltage : 5V DC Output voltage : 110V~210V AC Maximum driving ability: 15m EL wire Dimensions: 40mm x 32mm x 28mm Wire Length: 30cm (input) and 15cm (output) Interface: JST2.0 ...

Adjustable Integrated DC-DC Module- LM2596S
Price: $11.35
View
Availability: Stocked-NoBackOrder
Item #: EL-PCH2596M -

     I love this module so much! It is the upgrade version of the Adjustable Mini DC-DC Module. It integrated a volage meter with the DC-DC module ? LM2596S, with this function, you can monitor your project much more easier. The voltage meter can measure the input voltage or output voltage, which is adjustable by the protentiometer, with a precision of ?0.1V.Note that the voltage meter would not work if the input voltage below 4V. Press the button to switch voltage to...

1-Channel Solid State Relay Module
Price: $8.42
View
Availability: Stocked-NoBackOrder
Item #: EL-ARE00201SL -

   Compares with the traditional mechanical relay, the Solid State Relay (SSR) has many advantages: it has a longer life, with a much higher turn on/off speed and no noise. Besides, it also has better resistance to vibration and mechanical shock, and better moisture proof performance.        This Solid State Relay Module is based on Omron G3MB, to control current upto 2A@240VAC, can be widely used in various areas such as computer peripheral interfaces,...

Battery Holder - 8 x AA
Price: $3.34
View
Availability: Stocked-NoBackOrder
Item #: EL-PSB00802B -

The 8 x AA Battery Holder with Switch puts a nice finishing touch on your battery powered project. The battery install in the both side of the battery holder and it was two AA battery series connect in together. The 85mm cable is terminated with a standard 5.5x2.1mm, center positive barrel jack connector. Features 8 AA batteries With a DC jack male Rectangle configuration ...

HVFF Copper Union Straight Pneumatic Hand Valves
Retail: $2.90
Price: $2.23
View
Availability: Stocked-NoBackOrder
Item #: EL-DIY14520V -

If you need a general-purpose pipe joints valve switch, it can help you, you need to choose a tube of 4mm diameter, may be a fluorine plastic or PU tube, but you should notice that silicone tube can not be used with it. It can work at harsh environment with long worklife.Featureshand valve are deisgned to turn on and off the airflowSuitable for 4mm tubeLong worklifeSpecificationsMedia: Air or VacuumOperating Pressure?0 ~ 1.0 MPaNegative Pressure?-750mmHgPressure Proof?1.5 MPaOperating...

ESP8266 IOT Weather Station Kit
Price: $83.35
View
Availability: Stocked-NoBackOrder
Item #: EL-CRT13450K -

When we want to get up early every morning to understand the weather conditions outside, or we want to DIY a weather station. What is more we want to be able to build a smart home product of the initial model, this ESP8266 IOT Weather Station Kit is based on esp8266 wifi function to achieve remote data transmission products, through the three sensors to collect temperature and humidity information and to achieve water droplets detection And UV intensity testing. Three sensor performance is...

Micro DC Geared Motor Set
Price: $8.02
View
Availability: Stocked-NoBackOrder
Item #: EL-RPL11302K -

    The 5V, 83rpm Micro DC Geared Motor with Back Shaft is ideal for DIY enthusiasts. The wheel is match to the motor. This motor set are inexpensive, small, easy to install, and ideally suited for use in a mobile robot car. We recommend this L293 Motor shield to driver this motor. They are commonly used in our 2WD platforms. Specification Gear Ratio: 1:120 No-load speed(3V): 50RPM No-load speed(5V): 83RPM Torgue (3V): 0.8Kgcm Torque (5V): 1.0Kgcm Size: 69mm * 37mm *...

Micro-Speed Motor
Price: $3.14
View
Availability: Stocked-NoBackOrder
Item #: EL-RPL13002S -

    The 5V, 83rpm Micro DC Geared Motor with Back Shaft is ideal for DIY enthusiasts. This motor are inexpensive, small, easy to install, and ideally suited for use in a mobile robot car. We recommend this L293 Motor shield to driver this motor. There is a wheel set in here. Specification Gear Ratio: 1:120 No-load speed(3V): 50RPM No-load speed(5V): 83RPM Torgue (3V): 0.8Kgcm Torque (5V): 1.0Kgcm Size: 69mm * 37mm * 23mm Weight:30g ...

Solar Panel- 2W 6V
Spotlight!
Price: $11.93
View
Availability: Stocked-NoBackOrder
Item #: EL-PS0106GE -

    Need a clean energy source for your project? Check out this compact, high quality, high output endurable solar panel. This solar panel mates directly with many of our development boards and has a high efficiency. Unit has a clear epoxy coating with hard-board backing, provides an efficient and waterproof surface for the panel application on out-door projects. There is an adhesive tape on the top of the panel, Please pulled off it before using! Specification Dimensions:...

Plastic Case Raspberry Pi B+
Price: $5.01
View
Availability: Stocked-NoBackOrder
Item #: EL-RA0008AP -

     A firm& stable plastic case for raspberry pi B+, every port can be accessible with this case.      Spec Size: 90x70x24.8 mm ...

Basic Bread Board With Slot - 8.3*5.5 cm
Price: $3.84
View
Availability: Stocked-NoBackOrder
Item #: EL-PBB08555W -

Description This is a half size breadboard with dimension 8.3*5.5 cm. It has two power rails on the sides to allow more than one power level. In addition, it can make the breadboard as thin as 3.5cm and stick it onto an Arduino protoshield by pull the power rails off easily. With a total of 400 tie in points, all pins are spaced by a standard 0.1"(2.54mm). It has a self-adhesive on the back and also interlocking parts, so you can hook as many together as you'd like. Features 400 Tie Point Self...

Mini Bread Board 4.5x3.5cm - Clear
Price: $1.99
View
Availability: Stocked-NoBackOrder
Item #: EL-PBB05545T -

Description The dimension of this mini breadboards is 45 ? 35 ?9 mm?it have a self-adhesive backing and 2 x 17 rows of interconnected pins (5 per row) - 170 pins in total. Besides, it is able to combine several mini boards with slot. This board is very suit for those project that need compact dimension. Features 170 Tie Point Self adhesive Can be interlocked Dimensions: 45 * 35 mm ...

Basic Bread Board With Slot - 16.5*5.5 cm
Price: $9.02
View
Availability: Stocked-NoBackOrder
Item #: EL-PBB01655W -

Description This is a full size breadboard with dimension 16.5*5.5 cm. It has two power rails on the sides to allow more than one power level.With a total of 830 tie in points, all pins are spaced by a standard 0.1"(2.54mm). It has a self-adhesive on the back and also interlocking parts, so you can hook as many together as you'd like. Features 830 Tie Point Self adhesive Can be interlocked 2 power lanes Dimensions: 16.5 * 5.5 cm ...

Solar Panel- 1W 5.5V
Price: $4.91
View
Availability: Stocked-NoBackOrder
Item #: EL-PS0155GE -

    Need a clean energy source for your project? Check out this compact, high quality, high output endurable solar panel. This solar panel mates directly with many of our development boards and has a high efficiency. Unit has a clear epoxy coating with hard-board backing, provides an efficient and waterproof surface for the panel application on out-door projects.     There is an adhesive tape on the top of the panel, Please pulled off it before using!...

Solderless Bread Board - 17.6*4.6cm
Price: $4.73
View
Availability: Stocked-NoBackOrder
Item #: EL-PBB01655L -

Description This breadboard have 2x 60 rows of interconnected pins (5 per row) and two long rows on both sides - 700 pins in total. Its dimension is 17.6*4.6*8.3cm. Plesae note that it has no self-adhesive backing and no interlocking part.Features700 Tie PointDimensions: 17.6 * 4.6 * 8.3cm ...

Mini Bread Board 4.5x3.5cm - White
Price: $1.99
View
Availability: Stocked-NoBackOrder
Item #: EL-PBB05545W -

Description The dimension of this mini breadboards is 45cm * 35mm * 9 mm, it has a self-adhesive backing and 2 x 17 rows of interconnected pins (5 per row) -170 pins in total. Besides, it is able to combine several mini boards with slot. This board is very suited for those project that need compact dimension. Features 170 Tie Point Self adhesive Can be interlocked Dimensions: 45 * 35 mm ...

Mini Bread Board 4.5x3.5cm - Yellow
Price: $1.99
View
Availability: Stocked-NoBackOrder
Item #: EL-PBB05545Y -

Description The dimension of this mini breadboards is 45cm * 35mm * 9 mm, it has a self-adhesive backing and 2 x 17 rows of interconnected pins (5 per row) -170 pins in total. Besides, it is able to combine several mini boards with slot. This board is very suited for those project that need compact dimension. Features 170 Tie Point Self adhesive Can be interlocked Dimensions: 45 * 35 mm ...

Acrylic Enclosure Kit_A for Raspberry Pi B+
Price: $10.02
View
Availability: Stocked-NoBackOrder
Item #: EL-RA000078AA -

Keep your Raspberry Pi computer safe and sound in this lovely clear acrylic enclosure. This enclosure is special designed for the Raspberry Pi Model B+. It comes as 6 pieces of acrylic boards and some other modules such DC fan, heat sink and even screwdriver, to help user better experience with the Raspberry Pi Model B+.     This ingenious design has no screws or standoffs and there are cute little feet cut into the sides so that it stands up above your desk. There are...