All SLA 3D printed parts require washing to remove residual resin. Form Wash L automates this process, leaving you with smooth, clean, high-quality parts every time.
Once washing completes, parts are lifted out of the solvent to air dry, avoiding over-soaked, warped prints. The embedded solvent monitor helps you maintain peak cleaning performance by notifying you when it’s time to replace your solvent.
Use Form Wash L with all of your Formlabs SLA 3D printers. Wash one Form 3L build platform or two Form 3 build platforms with the included build platform adapter.
Designed to be a floor standing unit.
What’s Included
Form Wash L
Build Platform Adaptor
Solvent Pump
NOTE Unit requirements due to a large volume of IPA:
-Dedicated power capable of 1Ampere of current
-At least 0.9m from another electrical item
-Temperature of room 18-28 degC
-Replacement of the bucket will be required after 2000hrs of use, however regular use of the following resins will require bucket replacement after 500hrs of use: Rigid 10K and 4K, Tough 2K, Ceramic, Temporary CB, and Permanent Crown.