Hi, it's Fay here. I'm the one packing your orders out the back of MindKits, and I've got a confession: Bambu parts orders are some of my least favourite to send. Not because of the parts. It's because so many of them come with a note that says "urgent please, printer's down."

Nozzles clog. Wipers wear out. Build plates lose their grip after a few hundred prints, usually right before a deadline. None of that's a fault, it's just what happens to a machine that's actually being used. The trouble is it always seems to happen on a Friday, and then you're waiting on a courier over the weekend.
So we've put together a little stock-up deal to help you get ahead of it.
The deal
Use code STOCKUP5 at checkout for 5% off Bambu Lab parts and accessories when your order is over $100 inc GST. It runs until 31 January 2027.
Now, the honest bit, because I'd rather you knew up front than found out at checkout:
It's one use per customer. It doesn't stack with other offers. Printers and filament aren't included, it's parts and accessories only. And 5% isn't going to change your life. It's a small thank-you and a decent excuse to buy the spare you were going to need anyway, before you need it.
What I'd actually keep in the drawer
If you're printing a lot, a spare hotend is the big one. On the A1 and A1 Mini the hotend swaps out in a couple of minutes, no tools drama, so having one ready means a clog is a five minute job instead of a week off.
It's also worth thinking about nozzle size while you're at it. A 0.2mm nozzle gets you lovely fine detail but it's slow, and a 0.4mm is the everyday workhorse. This comparison from Bambu shows the difference pretty well - same boat, very different print times.

Printing carbon fibre or glow-in-the-dark filament? Go hardened steel. Those materials chew through a standard nozzle faster than you'd think.
After that, I'd grab a spare build plate. The dual-texture PEI plate is a good one because you get smooth on one side and textured on the other, so you can flip it depending on what you're printing. Textured hides the layer lines on the bottom and lets PETG let go nicely once it cools.

Then the cheap stuff that's easy to forget: nozzle wipers, a bit of PTFE tube, filament cutter blades. Small parts, but they're the ones that stop a print when they wear out.
Not sure what fits?
This is where I get keen. We've built a Bambu Lab Parts Finder where you pick your exact machine, anything from the A1 Mini through to the P2S, H2D and the AMS units, and it hides everything that won't fit. No more squinting at part numbers or guessing whether the P1 hotend goes in an X1 (it doesn't, by the way).
If you're still stuck, flick us a message and Jase or Sam will point you at the right bit. We'd much rather sort that before it ships than have you sending it back.
Anyway, that's my pitch. Get the spares in now, and hopefully I'll be packing fewer "urgent please" orders this summer.
Cheers,
Fay