This is a 2-pin JST RCY connector typically used for low-voltage applications running 3A or less. They are commonly found in RC vehicles. These come in a bag of 1 male plug, 1 female plug, plus pins to connect them both. The pins crimp to your cable and are inserted into the housing. 1 male socket 1 female socket 4 pins Documents: Datasheet
This is a 3-pin, through-hole PH series JST connector. The pins are spaced by 2mm. We really like the solid locking feeling and high current rating on these small connectors. This connector mates with our 3-pin jumper wire, and may be useful for interfacing with the popular Sharp infrared proximity sensors or our serial LCDs. Documents: Datasheet ...
Two pin, compact surface mount connector. We really like the solid locking feeling and high current rating on these small connectors. We use these all the time as battery connectors. Documents: Datasheet
This is a 2-pin, through-hole PH series JST connector. The pins are spaced by 2mm. We really like the solid locking feeling and high current rating on these small connectors. This connector will mate with all of our LiPo batteries. Documents: Datasheet
Here is a six pin horizontal 1.0mm pitch connector. It is useful if you need something very tiny as a connection. These are not the standard JST type connectors we use on most of our boards, but are actually the much smaller JST-SH type. Check the drawing below. Documents: Drawing
Two pin, compact surface mount connector. We really like the solid locking feeling and high current rating on these small connectors. Documents: Datasheet
Here is a tiny 4-pin Qwiic 1mm JST connector. This connector is used on all of our Qwiic-based boards and can be used to create your own I2C-based device compatible with the Qwiic system. Additionally, this connector will mate with all of our Qwiic cables with a solid lock. The SparkFun Qwiic connect system is an ecosystem of I2C sensors, actuators, shields and cables that make prototyping faster and less prone to error. All Qwiic-enabled boards use a common 1mm pitch, 4-pin JST connector....
Here is a tiny 4-pin Qwiic 1mm JST connector. This connector mounts to allow you to connect your cable vertically, great for tight spaces. This connector is used on all of our Qwiic-based boards and can be used to create your own I2C-based device compatible with the Qwiic system. Additionally, this connector will mate with all of our Qwiic cables with a solid lock. The SparkFun Qwiic connect system is an ecosystem of I2C sensors, actuators, shields and cables that make prototyping faster and...